Construction

What goes into a Radiant shutter.

A panel is a few parts, each with a clear job. Slide them apart, turn the louvers, and see what you can choose and how it is made.

The louvers

Louvers

Three sizes, and about 180° of control.

Choose 2½ in, 3½ in or 4½ in louvers to suit your windows and the look you prefer. They turn through approximately 180°, so you can welcome daylight, direct it where you want it, or close them for privacy.

How Radiant makes it

Ultrasonically welded end caps.

A cap is welded to both ends of every louver.

Ultrasonic welding uses high-frequency vibration to fuse the cap and the louver together. Every louver in a Radiant panel is finished this way at both ends, for a secure and carefully made construction.

The tilt rod

Tilt rod and clips

One rod turns every louver in the panel together.

The rod can sit at the side of the panel or in the middle, on the room side or the window side. A small clip joins each louver to it. At the side, the clip pins into the louver's end cap. A rod in the middle uses a wishbone clip, seated in a small slit in the edge of each louver. Which arrangement suits you depends on the look you prefer and the depth your window allows; your dealer will measure and advise.

The panel

Stiles

The two vertical sides of each panel.

The stiles give the panel its structure and hold the pivots that every louver turns on.

Top and bottom rails

The horizontal members that complete the panel.

Fastened to the stiles, the rails close the panel above and below the louvers to make a strong outer frame with a clean finish.

The 3D shapes are provisional: drawn from photos of a 3½ in sample and of the two tilt-rod clips, with the 2½ in and 4½ in louvers scaled from it. They will be replaced by the manufacturing drawings. The welding view is an illustration of the result, not of the equipment. Hinges, frames and a divider rail are shown in the simulator.

Design your shutters